Free CCO practice test
25 exam-style questions from across the mobile crane core topics. Pick an answer to see whether you were right and which rule decides it.
25 CCO practice questions with answers
Original questions on the topics in the CCO candidate handbook outline. Reviewed November 2026.
-
Definitions
1.The boom angle indicator on a carry deck crane reads the angle of the boom relative to:
Show answer
Answer: A. the horizontal. The indicator reads boom angle from horizontal — the same reference the load chart uses.
-
Crane Types
2.A key advantage of a telescopic boom over a lattice boom is:
Show answer
Answer: B. Much faster setup — it self-erects hydraulically with little or no assembly. Telescopic booms extend hydraulically for quick self-setup, while lattice booms must be assembled from pinned sections, often needing an assist crane.
-
General Knowledge
3.When a boom extension is in a stowed position, it is:
Show answer
Answer: D. pinned to the base section. A stowed boom extension is swung back and pinned to brackets on the base section of the main boom — it stays on the crane but is not erected at the boom head.
-
Technical Knowledge
4.Who establishes the crane's inspection, testing, and maintenance program under B30.5?
Show answer
Answer: A. The crane owner, who informs the crane user of its requirements. The crane owner establishes the inspection, testing, and maintenance program and informs the user of it.
-
Wire Rope
5.On a single-part (single line) reeve, where should the hoist line run at the boom tip?
Show answer
Answer: B. Over one of the centre sheaves, beside the boom centreline. Reeving to one side of the boom tip applies torsional load and twists the boom. Running single-part line on a centre sheave, and distributing multipart line evenly on both sides, keeps the boom in pure bending.
-
Pitch Diameter
6.Per the D/d strength-efficiency chart, a wire rope sling bent around its own diameter (D/d = 1) retains about:
Show answer
Answer: B. 50 percent of its rated strength. At a D/d of 1:1 the sling retains roughly 50 percent efficiency — the sharpest practical bend on the chart.
-
Load Calculation
7.What is the rule-of-thumb safe working load for a standard eye hook?
Show answer
Answer: D. The diameter of the eye in inches, squared, in tons. Safe load in tons = eye diameter in inches squared. Examples: 2 in eye = 2 x 2 = 4 tons; 4 in eye = 4 x 4 = 16 tons.
-
Load Charts
8.On a load chart, a capacity value printed above the bold (heavy) line or marked with an asterisk is limited by what?
Show answer
Answer: C. The crane's structural strength. Ratings above the heavy line (or asterisked) are structurally limited capacities — the crane's structure governs, not tipping.
-
Site Setup
9.For lattice boom assembly, the crane should be set up…
Show answer
Answer: A. In the quadrant of maximum capacity with the swing lock set. General assembly precautions call for setting up in the quadrant of maximum capacity with the swing lock set and the crane leveled.
-
Power Lines
10.A crane must travel near power lines at night. The employer must ensure that…
Show answer
Answer: C. The lines are illuminated or another means of identifying their location is used. For night or poor-visibility travel, the power lines must be illuminated or otherwise identified, and a safe travel path identified and used.
-
Operation Aids
11.What is the danger of using the override control on a boom hoist limiting device?
Show answer
Answer: D. The limiting device is inactive, so the boom can come back hard against the stops and be damaged. With the limiter bypassed there is nothing to slow the boom near maximum angle, and a hard strike on the stops can buckle boom or damage the pendants.
-
Mobile Crane Essentials
12.Assembly and disassembly of truck cranes should be performed with the outriggers in what position?
Show answer
Answer: B. Fully extended. Truck crane assembly and disassembly should be done on fully extended outriggers.
-
Standards
13.Operator certification under 1926.1427 must be specific to…
Show answer
Answer: C. The type/category of equipment (and, per the certifying body, capacity). Certification is by equipment type/category (some bodies also by capacity); a card for one type does not cover every crane.
-
OSHA 1926 Subpart CC
14.According to OSHA 1926.1408 Table A, the minimum clearance distance for power lines over 50 kV up to 200 kV is:
Show answer
Answer: A. 15 feet. Table A requires 15 feet for lines over 50 to 200 kV.
-
ASME B30.5 (Mobile Cranes)
15.According to ASME B30.5, telescopic boom cranes shall be equipped with an anti-two-block device or a two-block damage prevention feature, while lattice boom cranes shall be equipped with:
Show answer
Answer: C. An anti-two-block device or a two-block warning feature. Para 5-1.9.10.1 requires telescopic boom cranes to have an anti-two-block device or damage prevention feature for all points of two-blocking; lattice boom cranes may use an anti-two-block device or a two-block warning feature.
-
Standards & Violations
16.The sling-tension multiplier at 45° is…
Show answer
Answer: D. × 1.414. 45° from horizontal multiplies each leg’s tension by 1.414.
-
Definitions
17.The gantry (A-frame) is a structural frame that…
Show answer
Answer: A. Extends above the superstructure and anchors the reeved boom support ropes. The gantry, or A-frame, extends above the superstructure and is where the boom support ropes are reeved.
-
Crane Types
18.Erecting a long lattice boom on the ground often requires:
Show answer
Answer: A. An assist crane and manual assembly of pinned insert sections. Lattice sections are pinned together on the ground and raised by the boom hoist; assembly frequently needs an assist crane and a crew, unlike a self-erecting telescopic boom.
-
General Knowledge
19.According to OSHA 1926.1431, the total load (with the platform loaded) must not exceed what percent of the rated capacity for the radius and configuration of the crane or derrick?
Show answer
Answer: B. 50%. OSHA 1926.1431 limits personnel platform lifts to 50% of the crane's rated capacity for the radius and configuration.
-
Technical Knowledge
20.Which of the following will occur when lifting a load from the water?
Show answer
Answer: A. the load on the crane increases as the object leaves the water. While submerged, buoyancy supports part of the object's weight. As the load leaves the water it loses that buoyant support, so the load on the crane increases — the crane must be sized for the full out-of-water weight.
-
Wire Rope
21.What must happen to a wire rope that has contacted an energized power line?
Show answer
Answer: C. It must be replaced entirely. Power line contact is a Category III deficiency where cutting off the damaged portion is not an option; the rope must be replaced.
-
Pitch Diameter
22.The minimum recommended D/d ratio for a HAND-TUCKED splice wire rope sling is:
Show answer
Answer: B. 15 to 1. Hand-tucked splice wire rope slings require a minimum D/d of 15:1; below that the rated load must be reduced.
-
Load Calculation
23.What is the formula for the weight of a solid pyramid?
Show answer
Answer: D. width x length x (height/3) x unit weight. Weight solid pyramid = width x length x height/3 x unit weight. Similarly, a solid cone = 3.14 x (d x d)/4 x height/3 x unit weight.
-
Load Charts
24.What increases the total allowable line pull available at the hook?
Show answer
Answer: A. Adding more parts of line. Allowable line pull is the single-part pull times the number of parts of line, so reeving more parts raises the total pull (up to the chart capacity).
-
Site Setup
25.Why should a sledgehammer not be struck directly on the end grain of cribbing timbers?
Show answer
Answer: D. Repeated hammering can shatter the timber's interior even though the outside still looks sound. Interior crushing destroys bearing strength invisibly, so the crib can fail suddenly under the outrigger reaction.
You scored
That was 25 core questions. The app has the full bank, tracks every miss and brings it back until you have it.
A free practice test for every CCO written exam
Core is the exam every mobile crane operator takes. The specialty tests cover the crane you are certifying on.
Study the whole exam, not a sample
5,000+ practice questions across core and every specialty, timed practice exams, a load chart trainer and audio lessons. One payment of $197 covers 12 months.
CCO practice test questions
Is this CCO practice test free?
Yes. All 25 questions, their answers and the explanations are on this page. There is no account to create and nothing to pay.
Are these real CCO exam questions?
No. CCO does not publish its exam questions. These are original questions written to the topics in the published exam outline, with the OSHA or ASME rule behind each answer.
How many questions are on the real CCO core exam?
The mobile crane core written exam has 95 multiple-choice questions and a 90-minute limit. Calculators are not allowed on core.
What score should I aim for?
CCO does not publish a percentage cut score. Aim for 80% or better on every topic in practice before you book the exam.
Is there a practice test for my specialty?
Yes. There are separate free tests for swing cab (TLL), fixed cab (TSS), lattice boom (LAT), tower, overhead and articulating cranes, rigger and signalperson.